Jorge Otero, founder of Yacht Masters Hub. Sources checked 14 Nov 2026.
Short answer. Volvo Penta IPS (Inboard Performance System) uses individually steerable drives under the hull, each with forward-facing, twin counter-rotating propellers, run by electronic controls.[1][2] Service follows the Volvo Penta Service Protocol for your exact designation, by months or hours, whichever comes first.[3][4] The IPS operator's manual says to check drive oil daily, replace anodes at about one-third eroded and check ground braids yearly.[2]
Service intervals, from two Volvo Penta Service Protocols
Use the protocol for your own product designation (from the engine/drive plate, or Volvo Penta's Product Center). Two examples, "whichever occurs first":[3][4]
| Item | IPS10-A protocol[3] | D6-435D-F protocol (D6 with IPS)[4] |
|---|---|---|
| Engine oil and filters | 24 mo / 200 h | 12 mo / 200 h |
| Fuel pre-filter and fine filter | 12 mo / 200 h | 12 mo / 200 h |
| Anodes (protection system) | Inspect 12 mo / 200 h | Inspect 12 mo / 200 h |
| Seawater pump impeller | Replace 24 mo / 400 h | Inspect 12 mo / 200 h; replace 24 mo / 400 h |
| Transmission (drive) oil and filter | 24 mo / 400 h | 12 mo / 400 h |
| Corrosion protection, IPS housing to clamping ring | Inspect 12 mo / 400 h | Inspect 12 mo / 400 h |
| Drive belts | Inspect 12 mo / 200 h; replace 48 mo / 800 h | Inspect 12 mo / 200 h; replace 48 mo / 800 h |
| Exhaust plate | Inspect every 1,200 h | Inspect every 1,200 h |
| Propeller shaft seals | — | Replace every 1,200 h |
| Coolant; seawater pump overhaul | 48 mo / 2,000 h | 48 mo / 2,000 h |
Volvo Penta's warranty requires those services and records of them. It excludes defects likely caused by repair work, including software updates, done by a workshop that isn't a Volvo Penta Business Partner.[5][6]
Owner checks from the IPS operator's manual[2]
- Drive oil: check every day before starting; the drive must have been shut down at least 12 hours for a correct reading.
- Anodes: two per drive (one on the drive, one on the transom). Replace at about one-third eroded. Clean with emery cloth just before launch, never a wire brush.
- Ground braids: check every year. Volvo Penta warns electrolytic corrosion damage "occurs rapidly and is often extensive."
- After a grounding or impact: check drive and propellers for damage or vibration. If found, run to harbor at reduced speed, haul out and have an authorized Volvo Penta workshop inspect the drive.
- Faults: on D4/D6 engines, stored fault codes "can only be read and erased by a service technician."[6]
Volvo Penta's own claims: "up to 30% fuel reduction," and up to 40% longer cruising without refuelling than with an inboard engine.[1]
FAQ
What does IPS stand for? Inboard Performance System.[1][2]
How often do IPS drives need service? Volvo Penta publishes a Service Protocol per designation. On the IPS10-A protocol, drive oil and filter are due every 24 months or 400 hours, whichever comes first.[3]
How often should I change IPS anodes? Volvo Penta says replace an anode at about one-third eroded and check anodes at each annual service.[2][3]
Can any mechanic service IPS? Volvo Penta's warranty requires warranty work by a Volvo Penta Business Partner and excludes defects likely caused by repair or software work done elsewhere.[5]
What should I do after hitting something? Check for damage or vibration; if found, return slowly, haul out and have an authorized Volvo Penta workshop inspect the drive.[2]
Sources
- Volvo Penta, Volvo Penta IPS (leisure product page), undated, retrieved 14 Nov 2026.
- Volvo Penta, Operator's Manual, Volvo Penta IPS (IPS 350–600), 7747996, 10-2014.
- Volvo Penta, Service Protocol IPS10-A.
- Volvo Penta, Service Protocol D6-435D-F.
- Volvo Penta, International Limited Warranty Statement, Marine Leisure, 47715049, 07-2023.
- Volvo Penta, Operator's Manual D4/D6, 47716267, 05-2026.